MESO-Rx Sponsor Neo Anabolics (US DOMESTIC)

[Oldhand]

That’s not likely going to happen…your vials are being introduced to freezing winter temps in transport. The TC 250 vials I heated back into solution have not crashed again. I actually am pinning from one of them now. Zero pip.

@RintintinRedRocket

I’m with Matty on this one. You’ll most likely have good luck on the first heat up.

Crashed gear in winter is part of the game.

 

[Warrior2527]

There are plenty of reviews on the board from another vendor who has offered Test D 500 mg / ml. It's also included in sustanon 250. You can pin it that infrequently if you wanted to, but I think the main appeal is that guys who like to run higher dosages of test in their regimens can get away with much less injection volume, and it's painless. Lots of T400 and higher has PIP associated with it (though the 200 enan / cyp blends are ok). The T500 feels like nothing.

That's interesting, I only did a small Google search when reviewing. For me I probly won't touch it. Highest I ever ran my test was 500mg per week and when I got my blood test back my doctor about shit lol. She didn't ask if I was on gear in the first place so it was a nice surprise to her lol. Now I just run 200mg a cruise. I'm 35 and I'm strong as I ever been 385pr bench, 505 squat, and 580 dead sumo. At 200lbs at 5'10. And still clocking 4.7 40s. As I get older got away from being big big. 215 I was huffing and puffing going up stairs lmao. Thanks for the info!

 

[RintintinRedRocket]

That’s not likely going to happen…your vials are being introduced to freezing winter temps in transport. The TC 250 vials I heated back into solution have not crashed again. I actually am pinning from one of them now. Zero pip.

What method did you use to heat back into a solution ?

 

[cajunpauper]

Three of five of my test c vials came crashed. Should I heat now with coffee cup warmer or wait until I am ready to use in a few months
View attachment 375826

Just reheat. In these temperatures, Test C crashing en route is very common. Reheat once and you'll likely be fine. I had a pack a while back contain some crashed test due to similar temperatures. Re-heated and haven't had to put it back into solution since. If this were a lack of adequate solvents, that would be a different story. However, that's not the case here. Reheat and pin on.

 

[Oldhand]

What method did you use to heat back into a solution ?

I’ve had my best luck on a coffee maker