MESO-Rx Sponsor Genuine Steroid Powder Manufacturer-AASraw

[The-Squat]

no
good luck melting test base on it's own
View attachment 368756

Or ruin tren!

 

[The-Squat]

No BA? Lmaooo. Where the fuck do u clowns come from?! And u brewed all the easy stuff. Try brewing some TNE or other “preworkout” compound. I hope some of you guys aren’t UGL gear producers SMH. No wonder some people have golf balls in their ass.

This is!

Try just melting tren a with nothing but the powder and see how that comes out.

 

[Grally]

Clearly the idiot that ruined all his test C cannot LMAO. Sure any retard can put something on a hot plate… But can they also do it sterile, produce it within the targeted milligram concentration, and in a timely manner? Let’s not reduce it to being something so easy a fifth grader can do it SMH.

maybe without hate?
I raised temperature gradually over several hours
it didn't work
test cyp don’t help anything BB% and heating
Maybe problem with test cyp raw ?


today I brew test prop from aasraw
and it was easy dissolved and prop has higher melting point than cyp

 

[Photon]

maybe without hate?
I raised temperature gradually over several hours
it didn't work
test cyp don’t help anything BB% and heating
Maybe problem with test cyp raw ?


today I brew test prop from aasraw
and it was easy dissolved and prop has higher melting point than cyp

Start with 100ml TC and see if it brews first lol

 

[The-Squat]

maybe without hate?
I raised temperature gradually over several hours
it didn't work
test cyp don’t help anything BB% and heating
Maybe problem with test cyp raw ?


today I brew test prop from aasraw
and it was easy dissolved and prop has higher melting point than cyp

Talk to your rep!

 

[Grally]

Start with 100ml TC and see if it brews first lol

I even tried 10 ml, it didn't work.

 

[The-Squat]

@Grally did you even test the raws?

 

[Grally]

@Grally did you even test the raws?

I will send this week

 

[Photon]

I even tried 10 ml, it didn't work.

Sounds like TNE

 

[The-Squat]

Sounds like TNE

I'm thinking he got something shipped by mistake as well.

 

[readalot]

Melting point temperature is not needed if you add solvents like BB because it brings down the melting point. Surely one should have at least a temperature probe or a laser gun to monitor the mixture temperature to not overshoot by a lot.

For normal substances a temperature of 55c max is all is needed to dissolve completely the API and have a clear solution. Many times one can get away with even lower one but then it takes quite a bit to filter so I find an average KF 55c is a good balance between not too hot and not too cold.

All of this get thrown out of the window when one starts dabbling with orals injectables, especially the one with very high melting point.

TNE doesn't really need high temperature, just need the proper ratio of solvents to dissolve completely. Anadrol on the other hand...
But what temperature can't achieve time will do.

So one can heat the shit out of something or can just warm it to a reasonable temp and then let it stir for a very long time. It will get there (if the recipe is correct) it will just take some time.

Good practical summary. Just clarifying again dissolution is not melting. When you dissolve a solute in a solvent there is no melting point. Fundamentally different physical process.

https://www.askdifference.com/dissolve-vs-melt/

Amount of solute you can dissolve in a solvent is a function of their chemical composition (like dissolves like) and temp.