Hey, not sure where else to put this can’t comment in the underground, was getting my upcoming cycle ready, test,npp, mast, anadrol. All from Axle. When I got my order two of my mast P 200 vials were crashed hard, (have pics) I reached out to Axel they said to heat it up to get it back in solution. I attempted to do that and it gets close but still very visible crystals in the vial. I reached out to Axel on how to make it right, get told that’s what happens and he’s closing for a month with no attempt to make it right. This is what you run the risk buying ugl but figured I’d try to let the community know about at least my experience with “ customer service” hopefully other guys have better luck!
MESO-Rx
Anabolic Steroids
Axle mast issues
- Thread starter Bane88
- Start date
Tub of boiling water several times
Deezznutzz
Member
Try a coffee pot burner. Water is dumb. Bacteria .
Will give it a shot, I have always used hot water in the past for crashed gear or heating up the oil filled barrel, not saying it’s right lol just what I have done in the past.
Deadpool99
Member
I'm sending their mast e and test e vials to Janoshik and also getting bloodwork. Had them shipped to my apartment and after my vacation ends (august 29) Imma send them. First time trying axle and I hope their mast is legit. I also have never dealt with crashed gear. Hopefully I don't fuck it up and hopefully it's legit. Would love to hear updated on the effectiveness of the Masteron. I also figure 200mg concentration is significantly more likely to crash than 100 mg/mL, but I also hate injecting 5ml per week worth of masteron.
Keep us updated if you dm.
Keep us updated if you dm.
Oldhand
Member
The coffee maker should work. Take the vial off now and again and shake it. You could also try a frying pan on low heat if you don’t have a coffee maker and you’re a keurig guy.
If that doesn’t work, use the oven. You can set the temp to 250 and heat up the vial in there for 1/2 hour. Remember to vent the vial with a syringe needle. Keep the needle in the air pocket of the vial. If it is in the oil, as the oil heats and expands it will come out the needle and be wasted.
Finally there is the old microwave trick. You toss it in there for a few seconds at a time, shaking it between runs. You would think the metal crimp cap would cause a lightening show but it won’t. There are no sharp edges in the cap, and for whatever reason that matters. This is not a trick to ruin your microwave. It works, I’ve done it myself.
*** Use the microwave as a last resort. I had something crash years back and it had to get HOT to bring it back***
If that doesn’t work, use the oven. You can set the temp to 250 and heat up the vial in there for 1/2 hour. Remember to vent the vial with a syringe needle. Keep the needle in the air pocket of the vial. If it is in the oil, as the oil heats and expands it will come out the needle and be wasted.
Finally there is the old microwave trick. You toss it in there for a few seconds at a time, shaking it between runs. You would think the metal crimp cap would cause a lightening show but it won’t. There are no sharp edges in the cap, and for whatever reason that matters. This is not a trick to ruin your microwave. It works, I’ve done it myself.
*** Use the microwave as a last resort. I had something crash years back and it had to get HOT to bring it back***
phenominal34
Banned
Coffee pot / candle warmer 100%
Heat it both upright and upside down. Shake and continue to heat till crystal clear
Heat it both upright and upside down. Shake and continue to heat till crystal clear
Similar threads
