MESO-Rx
Anabolic Steroids
Titanium Gear Industries (domestic source)
- Thread starter TitaniumGear (TGI)
- Start date
50 mg a day 25 am 25 pre workout, no other sides then possibly this that I noticed, but this could be due to the sust/ tren/ mast as well or just my diet. Loved it tbh, body responded extremely well. Great way for me to kick off the cycle, gained fast right out the gate, possibly too fast
Price ?
Priceless.
Will do, time to get serious. ESP after I’d not touched fast food for essentially 2.5 years get on a cycle decide to dirty bulk throw a bunch of shit into me that was foreign up to my body at that point. Starting to think it wasn’t too smart but def helped me get the size I need to put on, now it’s time to shape and tone it
Nah, the opposite. If it went into the vial hot, when it cooled it would create a vacuum and pull the stopper in. Just like canning.
Ok. Just a hypothesis. You got any idea what would do it? I'm at a loss.
JackSmooth
Member
Silicone is more resistant to benzyl benzoate than butyl. That is the only info I have to offer.
JackSmooth
Member
@TitaniumGear (TGI)
This is a syringe filled with npp. only solvent used is BB and the rubber plunger was originally flat. after some time you can see how much its bulged. A silicone plunger would not have bulged this much over time.
This is a syringe filled with npp. only solvent used is BB and the rubber plunger was originally flat. after some time you can see how much its bulged. A silicone plunger would not have bulged this much over time.
So, in your opinion, do you think a recent made batch of gear could cause stopper deformation or bulging due to BB exposure?@TitaniumGear (TGI)
This is a syringe filled with npp. only solvent used is BB and the rubber plunger was originally flat. after some time you can see how much its bulged. A silicone plunger would not have bulged this much over time.
JackSmooth
Member
That plunger had direct contact with BB for months before those effects happened to its entirety. I have another syringe full of tren where the plunger mushroomed between 1-2 weeks.
Out of this batch how many were reported as deformed? What was the duration before they became deformed? How were these deformed ones stored(upright vs upsidedown or laying on its side)?
Assuming at the time you capped all of these there was no deformities.
Measuring all my cap heights. Swear to fuck if one is even .002mm off I’m getting a full refund. Including orals lol
<3
<3
Oh no my man...i have 0 reports of deformed stoppers. I saw this on another source thread and am trying my best to be preemptive about it is all. It's new and not been experienced by me thus far so I was curious as to the cause. Again, none of my wares have ever been reported to have this condition.
0 have been TGI. Check another thread.
JackSmooth
Member
Oh in that case theres too many unknown variables to pin point the cause. I have had gear sit in vials for 2 years now and nothings happened to me either. I would not worry if I was you, it could even be out of your control if it was an error in the manufacturing process.
Ok. I agree about the variables. I appreciate you looking out man.
Worf
Member
I've seen gear sit for nearly a decade with a fine stopper. Just make sure it's stored upright (liquid contents not in direct contact).
That said, I can't speak to EO or other more exotics...this was pharma BA/BB and safflower I believe or some other very standard carrier.
Similar threads
