Suspension Problem!! HELP!!

I have some 100 mg/ml underground suspension and it keeps clogging the needle!! How can I fix this? I am using 23 gauge needles and they worked before!!

LMK
 
ButterFlyEffect said:
I have some 100 mg/ml underground suspension and it keeps clogging the needle!! How can I fix this? I am using 23 gauge needles and they worked before!!

LMK

you can try heating it. are you sure this gear is good?
 
you don't let it sit for a long time once it's loaded in the syringe, do you? is it in a sealed vial? my friend gets underground shit in tupperware-type containers from some chemist. it can be hard to shoot if it dries out at all, even in a loaded syringe. niko
 
ButterFlyEffect said:
I have some 100 mg/ml underground suspension and it keeps clogging the needle!! How can I fix this? I am using 23 gauge needles and they worked before!!

LMK

if it is real, hold the pin in an upward position. also i have heard that there are only a few susp that will fit past a 23g pin espec ug gear. may need to go ouch bigger. i want to do susp bad but every one talks about inject problems.
 
This is the new guy omnilabs suspension. I simply draw it up and get it ready then stick it in my leg and it wont budge. Like something is clogging up the syringe!
 
I've only used suspension (RWR) once, and it would easily clog a 22g. So I'd run the loaded syringe under a stream of really hot water for a minute, then right before injecting, I'd shake the syringe really hard for a few seconds, to keep it from settling, then immediately inject.

KB
 
Had The Same Problems With Test Suspension And Winny. Drop To An 18 Gauge- You Can Hold That Sucker Up To Your Eye And You Can See Day Light Through The Other End.
 
Back
Top