SLU-PP-332 Solution Discussion

[actionjackson6699]

Easiest way to get a clear solution is to make a concentrated stock solution of DMSO then you can mix it into your basic steroid oil mix. Here: https://www.medchemexpress.com/slu-pp-332.html the third method described states 10% DMSO + 90% oil (corn oil is what they used for rats) but at 10% you would get some stinging. I have made a crystal clear solution up to 6mg/ml with only 5% DMSO, 1% BA, 15%BB and 79% MiG840 (MCT oil or any other oil would probably work too). This is with minimal mixing and heating. You can more than likely go higher since SLU is pretty soluble in DMSO. You should be able to make at least a 12mg/ml solution with 10% DMSO maybe more. I didn't try above 6 but saw a guy on YouTube made a 25mg/ml mix but not sure how much DMSO he is using in his final mix, he sells a kit for making a castor oil solution. He did say he uses DMSO though. The mixing order matters with this one! The trick is to put the SLU raw into the DMSO while mixing it with a stirrer it should go completely clear, then add the BA. In a Separate beaker mix the Oil with your BB, heat it a bit and get a magnetic stirrer going. Then take the stock DMSO SLU solution and start dripping it into the warmed oil vortex to slowly and evenly mix it little by little. It should make a crystal clear uniform solution than you can then filter and store in a sterile vial for injection. 5% DMSO is much better than 10% for injection comfort, at 5% you don't feel the DMSO at all it's like a normal oil based injection subq or IM...definitely much better than the 20% DMSO + BAC water mix that the DR guy on YouTube yella about in his videos. 10% would probably be ok too and if you really need it super concentrated you can probably take it up to 20% but that will have a little bite to it, still should not hurt like Kimera's injectable SLU though...

I would recommend using a cheap magnetic stirrer with hotplate from Amazon, makes things much easier. Amazon.com

 

[actionjackson6699]

Also nothing bad about using DMSO assuming you get the purest form and keep things clean and sterile. It's been studied for use in eye drops for cataracts, however, it is a super strong solvent that is attracted to water and will pull in just about any toxins it's exposed to. So I always use disposable sterile syringes when I use it, on a sterilized working area and dispose of the syringes after use. No double dipping and always keep the DMSO tightly sealed.

 

[actionjackson6699]

This is the guy that sells oil kits for making a caster oil solution for slu and other peptides. He also uses DMSO but does not disclose what's in his actual mix. I have NOT bought a kit nor do I plan to. Aside from using plastic with DMSO, he seems to know what he is doing, I don't like keeping DMSO solutions in plastic...



View: https://youtu.be/wtGXlIEUdXs?si=4HpeTnjoVUZ287TR

 

[Tanned_n_juiced]

Just got some MiG840 (Miglyol® 840) to try out instead of EO, trying to get 10mg/ml. Any other sources of slu raws? Only source j see now has only 100g for sale. Batch I have was from SSA but wonder if raws are different from different sources somehow. I do get a cardio boost from the injectable I made with the SSA raws so seems legit but didn't send it out for testing myself.

Mind sharing that source?

 

[vapor77]

Anyone know what Mike Arnold is using for his injectable SLU suspension he sells? It says it oil based but nothing more.

 

[actionjackson6699]

Anyone know what Mike Arnold is using for his injectable SLU suspension he sells? It says it oil based but nothing more.

This? SLU-PP-332 (in oil) – MA Research Chems says its a suspension. I wouldn't inject that...you would not get a consistent dosage from dose to dose. Plus this molecule is not water soluble and not soluble in oil without some DMSO to help so not sure that would even absorb properly.

 

[Aleksamara]

This? SLU-PP-332 (in oil) – MA Research Chems says its a suspension. I wouldn't inject that...you would not get a consistent dosage from dose to dose. Plus this molecule is not water soluble and not soluble in oil without some DMSO to help so not sure that would even absorb properly.

Hello. It is not known what was used for dissolution, but according to user reviews, both water and oil work well

 

[vapor77]

This? SLU-PP-332 (in oil) – MA Research Chems says its a suspension. I wouldn't inject that...you would not get a consistent dosage from dose to dose. Plus this molecule is not water soluble and not soluble in oil without some DMSO to help so not sure that would even absorb properly.

Thats the one.

There are quite a few guys on PM who have had good results with it including Luki.

I've been trying to avoid DMSO for injections so was looking at other options.

 

[svenstero]

Thats going to be my first attempt, depending if I tolerate the dmso. It cannot be any worse then the weird hippy concoctions ive ingesting in the past.

i just did 100 percent dmso so that 0.1ml is 250mg. Works well im using 0,6ml dmso equal 1.5mg slupp

 

[Sampei]

i just did 100 percent dmso so that 0.1ml is 250mg. Works well im using 0,6ml dmso equal 1.5mg slupp

Very healthy

 

[actionjackson6699]

i just did 100 percent dmso so that 0.1ml is 250mg. Works well im using 0,6ml dmso equal 1.5mg slupp

I would not inject or ingest 100% DMSO. I have used 100% DMSO for topical solutions of dihexa but I don't take that every day/multiple times a day. You can inject 1.5mg easily by just using a 5% DMSO solution...

 

[svenstero]

I would not inject or ingest 100% DMSO. I have used 100% DMSO for topical solutions of dihexa but I don't take that every day/multiple times a day. You can inject 1.5mg easily by just using a 5% DMSO solution...

no maybe i read it wrong, i use it oral not injected

 

[svenstero]

Very healthy

why?

 

[actionjackson6699]

no maybe i read it wrong, i use it oral not injected

Still a bad idea to ingest 100% DMSO multiple times per day every day. You only need enough DMSO to break apart the SLU and keep it in solution....

 

[actionjackson6699]

Still a bad idea to ingest 100% DMSO multiple times per day every day. You only need enough DMSO to break apart the SLU and keep it in solution....

Keep in mind that much DMSO will potentially affect other medications or substances you take as well...

 

[svenstero]

Still a bad idea to ingest 100% DMSO multiple times per day every day. You only need enough DMSO to break apart the SLU and keep it in solution....

is it really a problem at 0.6ml per day? using it for a while like that.

 

[svenstero]

Keep in mind that much DMSO will potentially affect other medications or substances you take as well...

so better to do the dmso peg combination?

 

[actionjackson6699]

so better to do the dmso peg combination?

I prefer DMSO + oil but at least DMSO + peg would have less of a risk of pulling random other substances you ingest directly into your blood stream.

 

[actionjackson6699]

Keeping a 100% DMSO solution clean would be hard too if you constantly open and dose from it. If you accidentally touch that dropper on something and put it back in the bottle and now whatever was on that surface it going to get absorbed in your next dose.

 

[svenstero]

Keeping a 100% DMSO solution clean would be hard too if you constantly open and dose from it. If you accidentally touch that dropper on something and put it back in the bottle and now whatever was on that surface it going to get absorbed in your next dose.

alright thank you, What oil would work? i tried dmso and destilated water but that didnt worked.