Retatrutide dosage

[viking76]

I was wondering if anyone that has had experience using Retatrutide could help me out with dosage. I'm not familiar with peptides and need some help on dosage.

If I get a 5ml vial, how much BAC water would I need to mix with Retatrutide if I wanted to inject 5ml a week? And how long would a 5ml vial last if injecting 5ml a week?

Any help would be greatly appreciated!

 

[viking76]

Where's the best spot to pin? Belly or love handles?

 

[hellerhiwater]

Where's the best spot to pin? Belly or love handles?

anywhere subcutaneous works. from booty cheeks, to stomach, to under the arm, to the forearm.

the "best" place is the place you're least sensitive and most likely to clean well, imo. bootycheek subq can be surprisingly painful in my experience, so i stick to the lower left and right quadrants of my stomach, toward the lovehandles but not quite there.

 

[Svenderschreckliche]

I have a question, as I'm not very knowledgeable about this and normally add 1-2ml of BAC to my 15mg Reta. If I now reduce my dose to 5mg/week and have a 15mg vial, can I mix it with 0.9ml of BAC, or when I reach 7.5mg/week, should I only mix it with 0.5ml to inject less liquid subcutaneously? Or, to put it better, is there a minimum amount of liquid required for dilution?

 

[Manualtrt]

Pharma tirz is generally 0.6ml per dose. I try to replicate within the 0.5-0.6ml range as much as possible. So if you have a 15mg vial and want to dose at 5mg per week I would reconstitute at 1.8ml of BAC and take 3 equal doses from that

 

[heavydutygorilla]

I have a question, as I'm not very knowledgeable about this and normally add 1-2ml of BAC to my 15mg Reta. If I now reduce my dose to 5mg/week and have a 15mg vial, can I mix it with 0.9ml of BAC, or when I reach 7.5mg/week, should I only mix it with 0.5ml to inject less liquid subcutaneously? Or, to put it better, is there a minimum amount of liquid required for dilution?

why not just add 1.5ml bac so that every unit on the syringe accounts for 1mg? At 5mg per week, you'd be injecting .5 ml which isn't much. I've always tried to reconstitute things so that they are 1mg per unit on the syringe for the sake of simplicity and consistency across all the peps I am running.

 

[Svenderschreckliche]

That's exactly what I had in mind. I wanted to inject as little volume as possible. But as Manuell already mentioned, at Apo Mounjaro they also use 0.6ml per shot. I just wasn't sure in general if there's a prescribed amount of BAC water needed to dissolve the powder, etc.

 

[azzor]

Main thing is you’re mixing up volume vs dose. I’ve used Retatrutide and the vial size doesn’t mean you inject that much, check how many mg are in the vial first, then do the math before adding BAC water.

 

[retaworldpeace]

5mg vial... Add 1ml of bac water. Each 0.10ml will equal 0.5mg.

Your starting dose should be 2mg. Run that until your body adjusts... Minimum two weeks. Form there, some people increase the dose by 1mg a week. I doubled it.

I went 2mg to 4mg to 8mg to 10mg.... two weeks at each dose. The jump from 4mg to 8mg was HELL. 10mg is far too effective and I just reduced to 6mg. I had to in order to hit my cutting macros.

Listen to your body. Download a peptide calculator.

Hope that helps.

Hope this isn't breaking the rules, but do you have a recommended vendor?

 

[PrairieSteel]

Hope this isn't breaking the rules, but do you have a recommended vendor?

I am in Canada and deal almost exclusively with Growth Guys. Best domestic pricing by a long shot and they jano test EVERYTHING. I can't say enough good things about them.

All the best

 

[Lokey]

Hope this isn't breaking the rules, but do you have a recommended vendor?

This is the best vendor.