RockyP
Member
For those new to the thread, Test D limit is 6 per client.
MESO-Rx
Anabolic Steroids
OEP LABS Domestic
- Thread starter OEP LABS
- Start date
TanFishMan
Member
Is the Test D also 12ml? It’s the only one not specifically noted on the list. Thanks
RockyP
Member
Pastebin says all oils 12 ml
Oldhand
Member
RockyP holding down the fort!!!!
RockyP
Member
My team is already being blown out so yea my afternoon is over. I’m doing my best to save Pench some time.
Update should be coming soon
Tdeck81
Banned
I wonder if he would be getting that kind of treatment if he was whitefishman.
BamaCrazy
Banned
Ravens, Jets or Raiders?? lol My Birds are taking care of business.
OEP LABS
Subscriber
Thank you Rocky you are correct sir 6 per member please. Got message from member, glad to have tight knit community messages relay quickly. The T500 is only being offered here. Tan fishman yessir it is 12ml also the T500. updated pastebin below
View: https://pastebin.com/wki2E32t
bigdaddyandfriends
Member
consider replacing your primo dose with DHB at 25% the dose. you'll likely get superior gains. the c1 methyl group added to DHB to produce primobolan attenuates the androgen quite a bit - it was added for oral bioavailability of the original acetate ester was (unlike the C2 methyl l group of masteron, which makes it resistant to 3a-HSD in skeletal muscle. Me replacing 350mg/wk primo for just 105mg/wk DHB resulted in noticeable strength gains within just two weeks, while primo was dissipating and DHB was building up. I did not front load it either.
If you use rely on primo for E2 control, add EQ at 50% of the dose, wise to front load it since the undecylenate ester takes so long time to build up otherwise. I don't believe EQ is a substrate for 5aR so, so they can be very complimentary. And DHB interestingly metabolizes largely to DHT via some unknown enzyme. Or just use aromasin.
I get zero PIP from the DHB I have (100mg/ml), from a source not on Meso. That is not the case for some 200mg/ml primo I have used in the past.
Either way you'll use many fewer mg with less overall oil to inject, with about 90% cost savings.
AllGoodThings
Member
AllbrandNew
Member
sionnach
Banned
Y'all gonna burn poor bro out in the first 5 min. God be with you, Pench.
OEP LABS
Subscriber
In regards to Test Cyp I let some invoices through but i have a feeling that will run out of stock. Shall we open early so folks have a go at everything? Apologies had to let everyone know in case yell needed something other than Test D-500
AllbrandNew
Member
It's only another ~30 min, and it would kind of suck to have folks miss because they were planning on sending after 7. Not sure what the right answer is here TBH. Maybe for anything other than the TD500?
OEP LABS
Subscriber
You’re absolutely right. Let’skeep it set in stone 7pm. As some may have appts or requirements
Wizbang
Member
how many people are watching the clock? 
crispybacon!
Member
Well, I just did my very first injection today… .65ml of OEP Test Cyp 250. Delt injection using Easy Touch 1ml LDS syringe & Nipro 30g 1/2” thin wall (drew with. 22g 3/4”).
Wasn’t sure what to expect, but it couldn’t have gone smoother. The Nipro went in with no resistance and I didn’t feel a thing. Had to apply more pressure than expected to get the oil through the 30g needle. But it wasn’t bad.
There was absolutely zero pip! Too early to say anything definitive, but I’m feeling pretty good about my choice to start this journey with @OEP LABS ! Will share bloodwork when the time comes.
Wasn’t sure what to expect, but it couldn’t have gone smoother. The Nipro went in with no resistance and I didn’t feel a thing. Had to apply more pressure than expected to get the oil through the 30g needle. But it wasn’t bad.
There was absolutely zero pip! Too early to say anything definitive, but I’m feeling pretty good about my choice to start this journey with @OEP LABS ! Will share bloodwork when the time comes.
OEP LABS
Subscriber
Lmfao!!!! Just bear with me my man and we will ride out the storm.Y'all gonna burn poor bro out in the first 5 min. God be with you, Pench.
Will use remaining time to quality check TD500.
If anything runs out I will announce it here.
Wizbang
Member
Oil so smooth it's a pleasure to pin - OEP Labs....do UGLs have slogans?
Similar threads
