Injectable Glutathione Recipe

[BigManBlastoise]

Glutathione didnt go clear until I started added NaOH to get the PH closer to 6-6.5 unless you use the L-Carnitine to do the same thing.

Was it milk colored to start though? I just couldn't imagine adjusting the ph changing it that much but I guess I've never done this kind of thing before and I've seen crazier things. I just didn't want to waste my l car raws being as skeptical as I was that the glutathione raws were correct. I'm open to making another attempt, but I'm also looking into purebulk raws

 

[Neegan02]

Correction, worst soreness I have ever experienced from an injection to date. Almost impossible to walk without a limp. Don’t think I will attempt again without diluting. Let me know if anyone else has experienced better luck with similar dosing

Diluted 1 mL of the original 250/400 solution with 0.5 mL BAC and took the shot. There was minor PIP upon injection this time, and the same lump with tenderness the following day.
First injection site of 200/400 is already improving, so it wasn't an infection issue.
Could this be a pH problem? Assumed that wouldn't really be a factor with the buffering from the carnitine. Any suggestions would be great.

 

[Photon]

Diluted 1 mL of the original 250/400 solution with 0.5 mL BAC and took the shot. There was minor PIP upon injection this time, and the same lump with tenderness the following day.
First injection site of 200/400 is already improving, so it wasn't an infection issue.
Could this be a pH problem? Assumed that wouldn't really be a factor with the buffering from the carnitine. Any suggestions would be great.

Post in thread 'Injectable Glutathione Recipe'

Saturday at 9:37 PM

Definitely not cold. Hadn’t been refrigerated yet, and I ran it under warm tap water for a minute or so before hand. Used a 1” needle as well so it really wasn’t shallow.

What dose do you usually run and did it at any point turn red during the brew?
Ideally it should remain at the right ---> 100uM.

• Photon

If it turned red during the brew then it's oxidised and needs to be remade.
If this is your first time injecting then you need to figure out which spots are pipless and whether subq or im works for you. It seems different for everyone.

 

[Duke309]

Was it milk colored to start though? I just couldn't imagine adjusting the ph changing it that much but I guess I've never done this kind of thing before and I've seen crazier things. I just didn't want to waste my l car raws being as skeptical as I was that the glutathione raws were correct. I'm open to making another attempt, but I'm also looking into purebulk raws

Yes, it looked like a glass of milk. I ended up at 400mg/ml L-glutathione, but ended up close to 7 on the pH which is a little to close to where it can start oxidizing. Check the pH on yours and adjust it to 6-6.5.