Getleanordie
New Member
Hello! Would appreciate for some input here? There is so much knowledge on these forums.
Just reconstituted first time hgh and I am not sure if it went bad or not. I used pharma sterile water 2ml for 41iu hgh from QSC. Then I added 30min later one more ml when I read here about this from @Ghoul. I added the first 2ml with 30g needle and the pressure might have been too high. Little bit went first straight to powder.
To be fair, a small enough amount of water to peptide ratio will always cause aggregation. No commercial pharma formulation is higher than 15iu/ml without special anti-aggregation ingredients (like polyaxamer 188), to prevent that from happening, allowing high concentrations of rHGH to be used:
It’s often those ingredients that prevent degradation in reconstituted form (like pens), that make it falsely appear to have a lower “purity” than UGL, btw...
So the ready recon hgh kinda looks ok in basic lighting but when look straight into light you can see its not perfectly clear. The vial with little less water is chinese bac (have not used it) for reference and the other is recon IPA. Vial with some bubbles on top is the HGH.Thinking that maybe the problem was the pressure? Or has there been some issues with hgh from QSC?
Just reconstituted first time hgh and I am not sure if it went bad or not. I used pharma sterile water 2ml for 41iu hgh from QSC. Then I added 30min later one more ml when I read here about this from @Ghoul. I added the first 2ml with 30g needle and the pressure might have been too high. Little bit went first straight to powder.
To be fair, a small enough amount of water to peptide ratio will always cause aggregation. No commercial pharma formulation is higher than 15iu/ml without special anti-aggregation ingredients (like polyaxamer 188), to prevent that from happening, allowing high concentrations of rHGH to be used:
It’s often those ingredients that prevent degradation in reconstituted form (like pens), that make it falsely appear to have a lower “purity” than UGL, btw...
So the ready recon hgh kinda looks ok in basic lighting but when look straight into light you can see its not perfectly clear. The vial with little less water is chinese bac (have not used it) for reference and the other is recon IPA. Vial with some bubbles on top is the HGH.Thinking that maybe the problem was the pressure? Or has there been some issues with hgh from QSC?
