Blend and melting points

[dragonlaboficial]

Hi guys, i'm new here and, before all, sorry for my bad english

So, i'm thinking to make a blend in that concetration

50mg test prop
75mg trem ace
75mg drost prop

totally 200mg/ml (if 'm right [)] )

however, those powders have differents melting points

test prop: 115~116°C
trem ace: 94~97°C
drost prop: 114~120°C

to make 20ml of this blend i'll need: 1g test prop, 1,5g trem ace and 1,5g drost prop; i know i have to mix those powders with the solvents (ba, bb, grapeseed oil) but how about the melting point?????
will i have to heat it till the melting point of drost prop? wouldn't it pip after cuz anothers AAS powders?

it's (still) sounds confused on my head

thanks fellas

EDIT

about the solvents concetration, i'm planning make it as usual: 2% ba and 20% bb

 

[Dr JIM]

They should NOT precipitate at room temperature, unless the solution is SUPRASATURATED!

Ergo based on the relative concentrations of each AAS you've listed, precipitation should NOT occur!

 

[dragonlaboficial]

@Dr Jim
hi man, is rly ok for u this set for the blend? ty



I was thinking that's little bb for that blend, whant do u think guys?

about the melting points, i SHOULD heat untill masteron's melting point, but how about the others components? weren't they harmed bcs of the high temperature??

ty