MESO-Rx Sponsor Axle Labs - US Domestic

Good god, vegetable oil? Right off the grocery store shelf.

What? No! That would be a waste.

“Recovered” vegetable oil. When not fully digested it conveniently floats to the top!

IMG_3353.webp

…remember, all oil is clear after run through a. 22um filter.
 
Axle Labs
ripper blend
20ml Test prop
10 ml test base
20 mg anavars
Landed yesterday pretty stoked ,
My area is pretty cold so the test suspension crashed i jus have to heat it up and roll the vial around some right?
 

Attachments

  • IMG_4644.webp
    IMG_4644.webp
    471.3 KB · Views: 91
  • IMG_4647.webp
    IMG_4647.webp
    264 KB · Views: 98
Axle Labs
ripper blend
20ml Test prop
10 ml test base
20 mg anavars
Landed yesterday pretty stoked ,
My area is pretty cold so the test suspension crashed i just have to heat it up and roll the vial around some right?
Yes, heating it up will work just fine. I place mine on the warmer for my coffee pot for 5-10 minutes.

TNE crashes all the time. You’re going to have to reclaim it a lot so find a convenient way that works for you.
 
Question here guys, ever since I came to the US and started Axle ( I love it)

I inject the same volume/concentration of gear in the same location in my glutes. there isn’t PIP that you get from crashed gear or that it’s painful to the touch, but it lingers when my glute is stretched, for example, when I put cross one leg above the other to put on my socks, I feel the pain.

Or when I bring my legs up to the sink to clean it, I get the same pain, so basically whenever I do these weird movements where the injection site is stretched, I feel the pain intensely.

I have been getting this pain ever since I came to the US 3 months ago and started using popular donestic gear on Meso. All my gear is tested, no high concentrations, same exact things I injected before.

My previous international gear never had this issue. For example ur run of the mill manufacturers like beligas found on Osgear/Steroidify.
 
Question here guys, ever since I came to the US and started Axle ( I love it)

I inject the same volume/concentration of gear in the same location in my glutes. there isn’t PIP that you get from crashed gear or that it’s painful to the touch, but it lingers when my glute is stretched, for example, when I put cross one leg above the other to put on my socks, I feel the pain.

Or when I bring my legs up to the sink to clean it, I get the same pain, so basically whenever I do these weird movements where the injection site is stretched, I feel the pain intensely.

I have been getting this pain ever since I came to the US 3 months ago and started using popular donestic gear on Meso. All my gear is tested, no high concentrations, same exact things I injected before.

My previous international gear never had this issue. For example ur run of the mill manufacturers like beligas found on Osgear/Steroidify.
Do you only do the same location on each glute?
 
Yes exactly. Maybe a minor difference would be test e going from 300mg/ml to 250mg/ml but that should make it better.

I also had a few weeks where the volume was cut into half and still had issues.
Does the viscosity in the oils you are using now look about the same when you draw it up, compared to what you used previously? Do you think the previous stuff might have had more solvent and been thinner and spread faster after injecting?
 
Does the viscosity in the oils you are using now look about the same when you draw it up, compared to what you used previously? Do you think the previous stuff might have had more solvent and been thinner and spread faster after injecting?
I have both rn, I can try checking. But I don’t notice a difference. Axle’s stuff is pretty smooth to draw up and inject.
 
I’m not an expert in brewing and the solvents. But could the solvent being higher concentration cause that? Maybe it’s my individual reaction.

But I feel like I would have gotten used to it by now.
 
Back
Top