MESO-Rx
Anabolic Steroids
Test E/Eq 500 Blend Homebrew QUestion
- Thread starter kingsatan
- Start date
cornedbeefhash
New Member
Could you make a Test E/Eq 500mg/ml Blend that was painless? Or would that be impossible? [}]
When you say 500mg/ml, what kind of breakdown of test and EQ? 50/50?
Yeah, 50/50 wasa what I was thinking.
Although I suspect it may be possible the upwards of 3% BA solution needed to lessen precipitation and bacterial colonization would not be "painless" for sure.
Consequently to maintain stability and sterility the maximal concentration for essentially any AAS approximates 400mg/ml.
(I have used some AAS at 500-600 mg/ml BUT it was not stable unless heated immediately before use since precipitation is inevitable at these higher concentrations)
Consequently to maintain stability and sterility the maximal concentration for essentially any AAS approximates 400mg/ml.
(I have used some AAS at 500-600 mg/ml BUT it was not stable unless heated immediately before use since precipitation is inevitable at these higher concentrations)
Because the progestogenic anabolics are the most non-polar of all AAS they may indeed reach concentrations about the 500/ml range (700 I seriously doubt is stable)
Nevertheless precipitation remains problematic at higher concentrations especially if said products are refrigerated, allowed to sit without periodic agitation or should a BA of less than roughly 2% be used.
Regardless it's your ass, so go for it mate be the Meso G. pig.
Heck, worst case scenario is the development of a sterile abscess providing the gear is not contaminated.
Nevertheless precipitation remains problematic at higher concentrations especially if said products are refrigerated, allowed to sit without periodic agitation or should a BA of less than roughly 2% be used.
Regardless it's your ass, so go for it mate be the Meso G. pig.
Heck, worst case scenario is the development of a sterile abscess providing the gear is not contaminated.
Looks tempting..
