OEP LABS Domestic


Do you think this Glut regimen will work equally well to mitigate Tren A (10-20 mg/day) or Anavar (50 mg/day) (separate stacks, wondering about both and which to run)?
Those are super mild. Did a dbol. and anadrol and then sdrol back to back 6 weeks with glutathione daily and my liver values came back the lowest I had in years, like not even on TRT they have been these low.

But again don't think you can abuse orals just bevause your liver values are good.

Orals pur strain on kidneys and a few promote liver tumors (mtren cough cough).

So don't overextend yourself
 
One day that's not for me though never got much out of it. but I seen some guys look like stone running ether long or short easter's how ever you say it not for me tho
Well see got a price quote wasn't bad but always caveats. Little bit of time we shall see.


The TC and TE issue has been resolved can't thank the community for working with me. I can assure you those handles that helped will be taken care of from this point forward and on.
 
Those are super mild. Did a dbol. and anadrol and then sdrol back to back 6 weeks with glutathione daily and my liver values came back the lowest I had in years, like not even on TRT they have been these low.

But again don't think you can abuse orals just bevause your liver values are good.

Orals pur strain on kidneys and a few promote liver tumors (mtren cough cough).

So don't overextend yourself
I know you super busy sampei but my a asked you a question about glutathione I'm still new to it but was want you 1st hand advice sir
 
Well see got a price quote wasn't bad but always caveats. Little bit of time we shall see.


The TC and TE issue has been resolved can't thank the community for working with me. I can assure you those handles that helped will be taken care of from this point forward and on
That's a blessing but as you said time will tell on the mast E. just like TRA now if that can be found lol

I know you fix the TE TC thing . your the best man
 
So what I’m hearing is I need to pay or inquire about the raw data to get the correct purity check on said material?

It's an extra $5 for raw data.

Let's say you email Jano for a raw purity test.
You can request it be reported as a range (default) or an exact figure (e.g 98%+ vs 99.1% .

What is 98%+?
Is it 98.01%? or 99.99%?

The raw data provides 2 values.
1765130285114.webp
1765130401818.webp

In 37mg of raws, 36.8mg was detected.
Thus 36.8/37 = ~99.5%

You can then brew with 99.5%.

That being said, pharma variance is 10%, so i don't think it makes a huge difference.
 
It's an extra $5 for raw data.

Let's say you email Jano for a raw purity test.
You can request it be reported as a range (default) or an exact figure (e.g 98%+ vs 99.1% .

What is 98%+?
Is it 98.01%? or 99.99%?

The raw data provides 2 values.
View attachment 365649
View attachment 365651

In 37mg of raws, 36.8mg was detected.
Thus 36.8/37 = ~99.5%

You can then brew with 99.5%.

That being said, pharma variance is 10%, so i don't think it makes a huge difference.
Say less sir thank you for this. About to send the MENT and also the Halo once it arrives. Will be sending a ton of finished oils to jano. The most suspenseful and anticipated one you already Know the TD-500!
 
Okay so with time to spare but was quite a challenging task, however that's exactly what I was looking for to be honest. So, if you haven't heard from me but know you should have, these are the folks within todays deadline, please reach out to me asap. Others remain and have not been forgotten for tomorrow you will be taken care of 100%.

So what's next?
Is to gather up 7-8 finished oils and send them off to Jano Team and validate the Hplc targets. Where the fun begins
 
Okay so with time to spare but was quite a challenging task, however that's exactly what I was looking for to be honest. So, if you haven't heard from me but know you should have, these are the folks within todays deadline, please reach out to me asap. Others remain and have not been forgotten for tomorrow you will be taken care of 100%.

So what's next?
Is to gather up 7-8 finished oils and send them off to Jano Team and validate the Hplc targets. Where the fun begins
Congrats! and take some time to take a breath and enjoy yourself.
 
Since you're doing it with a vial that will be used in a matter of a week or two, there's not going to be any significant degradation. Instead of heating to a high temp on a mug warmer multiple times, I'll do it once to dissolve the TNE back into suspension, then store it in a baby wipe warmer at a consistent temp that's warm enough to keep it from crashing, but significantly cooler than what it takes to dissolve it.

View attachment 353463
How long would you feel comfortable leaving a vial in one of these wipe warmers at at 105*F. A new vial of TNE might take me 3 months to go through.

Also do these create condensation on the vials?

I also have some opened vials that are like a year old but if they're not in the current rotation I wouldn't store them in there
 
How long would you feel comfortable leaving a vial in one of these wipe warmers at at 105*F. A new vial of TNE might take me 3 months to go through.

Also do these create condensation on the vials?

I also have some opened vials that are like a year old but if they're not in the current rotation I wouldn't store them in there

I haven't cross checked this info, so take it with a grain of salt and do your own research before committing to a temp you're comfortable with

Screenshot_20251203_171006_X.webp



Regarding condensation, this is a copy paste of a response I wrote to a similar question I had in my long term storage thread, so I apologize if it doesn't fit your question 100%;

"The only water that can be in the vial, assuming the seal is intact, is water that was already in there. Warmer air can "hold" more water, so as the air temperature goes down, any suspended water will condense, however this is not adding water to the vial, it's simply due to temperature change forcing the water that was already in there to condense."
 
I haven't cross checked this info, so take it with a grain of salt and do your own research before committing to a temp you're comfortable with

View attachment 365936



Regarding condensation, this is a copy paste of a response I wrote to a similar question I had in my long term storage thread, so I apologize if it doesn't fit your question 100%;

"The only water that can be in the vial, assuming the seal is intact, is water that was already in there. Warmer air can "hold" more water, so as the air temperature goes down, any suspended water will condense, however this is not adding water to the vial, it's simply due to temperature change forcing the water that was already in there to condense."
Thanks for that chart. Worked out perfectly, I found one that has a low setting of 86-95*F. Almost like it was meant for oils lol.
 
Back
Top