Need help with a masteron homebrew?

[choccotaco]

I'm having issues with my masteron homebrew, I can't get the masteron powder to hold after I heat it and it breaks down? It looks good and then I let it cool down and the powder re-separates from oil. I've tried a high B.A. and a high B.B. level and neither of them helped. I've tried re-heating it several times but what happens is that it'll break back down then separates when it cools. I've also tried putting it through watman filters while it was still hot but I still had no luck, once it went through the filter and then into the vile it would turn into straight powder. I know my powder is good because I got several other powders from the same source in the same shipment, and was extremely satisfied with all of it. When it re-separates as it cools it kinda clumps tougher and crystalizes at the bottom of the beaker and then will seperate from oil... ANY SUGGESTIONS ARE GREATLY APPRECIATED. Have a lot invested in this and already wasted a significant amount trying to figure this problem out. ALL OUT OF IDEAS AND IN NEED FOR SOME HELP.

 

[bigrobbie]

What dosages are u trying to achieve (per ml)?

 

[jw2031]

Try using 2ml ofguaiacol to dulute it before you start your other processes

 

[ski1969]

I am no pro at homebrew, but this site is a good reference...

Steroid bodybuilding, fitness and diet articles brought to you by basskiller

Take a look around. Maybe you can find some help/tips.

 

[Bill Roberts]

As mentioned, it will be needed for you to say how many mg/mL you are trying for, as well as how many grams of material you used and how much oil, BA, and/or BB.

Secondly, are you using the usual Masteron -- the enanthate ester -- or the propionate version?