5k|/\/ /\/ Y
New Member
men,
will this have any negative effects if i decide to stack this with my cycle?
will this have any negative effects if i decide to stack this with my cycle?
MESO-Rx
Anabolic Steroids
melanotan II, mt2
- Thread starter 5k|/\/ /\/ Y
- Start date
Renegade69
New Member
i hear it enhances libido, so a stiffy 24/7 could be a problem....or a gift lol
If your dosage you take is too high it will limit your appetite. Best to eat before dosing. Be careful with melanotan II if you have any moles (especially on the face) because they WILL darken and any smallish barely visible moles may become a bit more noticeable. For most folks this doesn't pose a problem (some folks even have moles removed) but it is definitely something that needs proper consideration. Melanotan II doesn't really cause a "tan" in the classic sense, what it does is cause one's overall pigmentation to increase. To have a proper natural looking tan getting a bit of UV can help (but really limit it because you can absolutely go too dark).
TZTARZAN2000
New Member
i am using it now and have used it on cycle. no prob for me. a little upset stomache so do eat first and it does make your moles very dark. and i also tan in a bed too! excellent results!
5k|/\/ /\/ Y
New Member
guys im afraid of un expected hardons at the job...lol any stories from you all?
Renegade69
New Member
lol where do you work, or what kind of job do you have - if you dont mind me asking....
If wood is not good during the day, pin at night. This way you can sleep through your raging boner. That's what I do!
Renegade69
New Member
5k|/\/ /\/ Y
New Member
well i recieved my mt2 today . ive already eaten and just reading up on how to dose. I work in an office , with LADIESSSSS...lol
Last edited:
5k|/\/ /\/ Y
New Member
ok boys, i have found the way id like to administer this see below:
To prepare for injection, it must be reconstituted with bacteriostatic water. You may use anything between 1ml and 5ml of water for your vial. Dependant upon the amount of water used will determine the concentration of your solution. For example, a 10mg vial of Melanotan II mixed with 1ml of water will provide a solution of 10mg per 1ml (10mg/ml). This means that a 1mg dose will require a shot of 0.1ml. Bearing in mind that the recommended starting dose is 0.25mg, using the example above, the actual volume of the shot would be 0.025ml ( of 1 tenth of a ml). This is a very small volume and very difficult to accurately dose even with a 0.5ml insulin syringe. Therefore, at least until your dosages have increased, it is suggested that you use more water for your vial.
An example of a good solution would be to mix 10mg of Melanotan II powder with 4ml of bacteriostatic water. This now provides:
10mg/4ml or 1mg/0.4ml or 0.25mg/0.1ml
0.1ml can be accurately measured using a 0.5ml or 1ml syringe.
Obviously, as your dosages become higher, you may dilute subsequent vials with lower amounts of water to reduce the volume of each shot. I would recommend that when you are using a dosage of 1mg, you reconstitute the vial with 1ml or 2ml of water so that each shot will be 0.1ml or 0.2ml respectively.
?my question is i have a 3ml syringe, would that mean that i would add 4l into that little bottle? will it even fit?
next question is : on an insulin syringe it reads from 5-30units , so under this plan how many units would i need if im gonna start off at the .25mg ? please advise.
To prepare for injection, it must be reconstituted with bacteriostatic water. You may use anything between 1ml and 5ml of water for your vial. Dependant upon the amount of water used will determine the concentration of your solution. For example, a 10mg vial of Melanotan II mixed with 1ml of water will provide a solution of 10mg per 1ml (10mg/ml). This means that a 1mg dose will require a shot of 0.1ml. Bearing in mind that the recommended starting dose is 0.25mg, using the example above, the actual volume of the shot would be 0.025ml ( of 1 tenth of a ml). This is a very small volume and very difficult to accurately dose even with a 0.5ml insulin syringe. Therefore, at least until your dosages have increased, it is suggested that you use more water for your vial.
An example of a good solution would be to mix 10mg of Melanotan II powder with 4ml of bacteriostatic water. This now provides:
10mg/4ml or 1mg/0.4ml or 0.25mg/0.1ml
0.1ml can be accurately measured using a 0.5ml or 1ml syringe.
Obviously, as your dosages become higher, you may dilute subsequent vials with lower amounts of water to reduce the volume of each shot. I would recommend that when you are using a dosage of 1mg, you reconstitute the vial with 1ml or 2ml of water so that each shot will be 0.1ml or 0.2ml respectively.
?my question is i have a 3ml syringe, would that mean that i would add 4l into that little bottle? will it even fit?
next question is : on an insulin syringe it reads from 5-30units , so under this plan how many units would i need if im gonna start off at the .25mg ? please advise.
TZTARZAN2000
New Member
bro use your 3 mil syringe just to draw the water out and put in powdered vial. u know have approxapatly 10 1 mg dosses. plenty. use a slin pin sub q in belly just as if you were diabetic. too easy! that will be plenty. E.D. GO TO A TANNIN BED 2 OR 3 TIMES. you will have nice tan before second bottle is gone. 
5k|/\/ /\/ Y
New Member
bro use your 3 mil syringe just to draw the water out and put in powdered vial. u know have approxapatly 10 1 mg dosses. plenty. use a slin pin sub q in belly just as if you were diabetic. too easy! that will be plenty. E.D. GO TO A TANNIN BED 2 OR 3 TIMES. you will have nice tan before second bottle is gone.
thanx bro . i will draw 1ml and pour it into the slin pin
Last edited:
IronCore
New Member
WTF is this guy doing? digging up EVERYTHING on melanotan and shilling it???
WHATS WRONG WITH YOU BRO? THIS ISN"T CRAIGSLIST!!!!
Will one of the mods PLEASE BAN THIS PUNK??!!??!!!
WHATS WRONG WITH YOU BRO? THIS ISN"T CRAIGSLIST!!!!
Will one of the mods PLEASE BAN THIS PUNK??!!??!!!
