pappaprime
New Member
I want to thank everyone here. I read every post before I attempted my first batch.
I made a small trial run of 100ml at 330mg/ml of test e. I used the recipe generated by the steroid calculator on the bass killer site. MAKE sure you find and change the displacement value for the compound you are intending to use. The raws were partially melted when it arrived. Test e has a low melting point so considering the ride this did not suprize me. I used a hotplate with no water bath. I started with the empty hot plate on low and checking the temp with a lazer thermometer. Once it was at a stable 150 I placed the beaker on it. I added 33 grams to the beaker and the BA and BB that the recipe called for. I stirred almost constantly. Checking the temp with the lazer until it was completely dissolved. The solution never rose above 110 degrees. Plate stayed about 150 160. Once dissolved I added the MCT oil and again stirring and waiting patiently until the entire solution was at 98 degrees. Used a sterile 18g to suck up 20 ml at a time and pushed it through a .22 syringe filter. What I learned. The lazer thermometer will give you great piece of mind. Buy one. The syringe filters suck. Royally. I was going to do the rest if the batch came out ok but it was so dam hard i said to hell with it. Im getting my pump set up as we speak. Now the hard part. To test it. I have a few ccs left of my other gear before I run this one. I think I will test a couple of tenths sub q to see how it feels.
It is crystal clear.
At 330 it dissolved very easily with litte heat.
I cant wait to see if it will have any pip or not.
I made a small trial run of 100ml at 330mg/ml of test e. I used the recipe generated by the steroid calculator on the bass killer site. MAKE sure you find and change the displacement value for the compound you are intending to use. The raws were partially melted when it arrived. Test e has a low melting point so considering the ride this did not suprize me. I used a hotplate with no water bath. I started with the empty hot plate on low and checking the temp with a lazer thermometer. Once it was at a stable 150 I placed the beaker on it. I added 33 grams to the beaker and the BA and BB that the recipe called for. I stirred almost constantly. Checking the temp with the lazer until it was completely dissolved. The solution never rose above 110 degrees. Plate stayed about 150 160. Once dissolved I added the MCT oil and again stirring and waiting patiently until the entire solution was at 98 degrees. Used a sterile 18g to suck up 20 ml at a time and pushed it through a .22 syringe filter. What I learned. The lazer thermometer will give you great piece of mind. Buy one. The syringe filters suck. Royally. I was going to do the rest if the batch came out ok but it was so dam hard i said to hell with it. Im getting my pump set up as we speak. Now the hard part. To test it. I have a few ccs left of my other gear before I run this one. I think I will test a couple of tenths sub q to see how it feels.
It is crystal clear.
At 330 it dissolved very easily with litte heat.
I cant wait to see if it will have any pip or not.
