Does mixing finished oils work?

[combover]

I have some finished tren a, mast e, test c. They all have rubber pieces floating. I grabbed some sterile vials and syringe filters and was gonna filter this stuff into new vials.

Can I mix 2 or 3 different finished conpinds (all mct) into one vial? If I heat and swirl before each injection, will I be close to an even mix or bad idea?

I found some threads with people arguing each side. Don't suppose anyone has done this then sent to jano?

 

[T&H]

I have some finished tren a, mast e, test c. They all have rubber pieces floating. I grabbed some sterile vials and syringe filters and was gonna filter this stuff into new vials.

Can I mix 2 or 3 different finished conpinds (all mct) into one vial? If I heat and swirl before each injection, will I be close to an even mix or bad idea?

I found some threads with people arguing each side. Don't suppose anyone has done this then sent to jano?

I don't believe you can get it mixed completely together where you will get half of each compound accurately when drawing, if combining 2 together. If I were you, just filter into individual vials. You're only saving a vial combining them, and those are cheap.

 

[combover]

I don't believe you can get it mixed completely together where you will get half of each compound accurately when drawing, if combining 2 together. If I were you, just filter into individual vials. You're only saving a vial combining them, and those are cheap.

Word. I have enough half vials that will be fine. Thanks.

I'm curious if I mixed the amber tren and clear mast if I'd be able to tell how good or bad it was mixed. I'm not trying to pinch pennies, just curious about convenience.

 

[combover]

Any idea how much oil I can push through each syringe filter?

 

[Laxbro88]

100mL or more

 

[Big_paul]

Any idea how much oil I can push through each syringe filter?

Since your gear was pre filtered you should be able to use 1 syringe filter.