Mostly posting a "thanks" to those that have helped newcomers understand the value of filtering, proper equipment and procedures....
My wife wanted to start TIRZ, and given my stock is CH UGL, i wanted to give her the best I could. The lypholized pucks from my source all have tested well, but out of 30+ vials, i did observe what looks like a stopper core shred laying on top of one, clean white puck. Went on to acquire nylon .22 nm(?) 13mm filters, with 25s delayed, some sterile vials and 3ml syringes.
1st vial is a TIRZ 20 mg, reconstituted with 2.0 ml BAC. I prewet the filter with a fresh draw of BAC, then filtered. Was surprised that the down stream end of the filter was not luer lock, but pressure fit cone...the luer lock needle did fit snugly, and didn't blow off.
Surprised/not surprised when my 13mm filter became plugged solid (would not pass air or TIRZ for the last few drops ~.03ml or so...). So thanks again to @Ghoul and others that have described this as not unusual, hence the need for 25mm filters in the storehouse.
Anyway she injected this am, and i felt like i have taken all the prudent steps to mitigate the risk of using these supposedly tested UGL peps. We both know USA pharma would be ideal but cost prohibitive and thus a barrier to the quality of life benefits they make available. If you are contemplating filtering, give it a try. I am probably not going to filter everything i pin...but definitely will do hers (sounds stupid...but my risk call).
Next on deck are TESA and some Test Cyp and HGH in a few months when i come off the TESA.
QUESTION: Other Peps I am researching include RETA,MOTS-C, NAD+, IPA, GHK/TB/BPA.....from this list are there any you would prioritize filtering?
Are there any filtering differences I should be aware of? differences from doing OILS vs lypholized PEPS?
My wife wanted to start TIRZ, and given my stock is CH UGL, i wanted to give her the best I could. The lypholized pucks from my source all have tested well, but out of 30+ vials, i did observe what looks like a stopper core shred laying on top of one, clean white puck. Went on to acquire nylon .22 nm(?) 13mm filters, with 25s delayed, some sterile vials and 3ml syringes.
1st vial is a TIRZ 20 mg, reconstituted with 2.0 ml BAC. I prewet the filter with a fresh draw of BAC, then filtered. Was surprised that the down stream end of the filter was not luer lock, but pressure fit cone...the luer lock needle did fit snugly, and didn't blow off.
Surprised/not surprised when my 13mm filter became plugged solid (would not pass air or TIRZ for the last few drops ~.03ml or so...). So thanks again to @Ghoul and others that have described this as not unusual, hence the need for 25mm filters in the storehouse.
Anyway she injected this am, and i felt like i have taken all the prudent steps to mitigate the risk of using these supposedly tested UGL peps. We both know USA pharma would be ideal but cost prohibitive and thus a barrier to the quality of life benefits they make available. If you are contemplating filtering, give it a try. I am probably not going to filter everything i pin...but definitely will do hers (sounds stupid...but my risk call).
Next on deck are TESA and some Test Cyp and HGH in a few months when i come off the TESA.
QUESTION: Other Peps I am researching include RETA,MOTS-C, NAD+, IPA, GHK/TB/BPA.....from this list are there any you would prioritize filtering?
Are there any filtering differences I should be aware of? differences from doing OILS vs lypholized PEPS?
